CSV Launcher Reassembly
Reinstalling the Trigger System
- Insure the spring is on the diaphragm. The spring fits on the nub on the back side of the diaphragm.
- If blue masking tape is applied over the valve (to keep it clean and free of shipping peanuts), remove it. Keep the area clean to avoid debris getting into the valve later.
- Place the diaphragm on the valve, making sure the holes line up and the spring faces away from the valve
- Place the six screws into the valve top
- Place the valve top on the valve aligning the holes
- Start each screw by gently turning backwards until it clicks, then gently forwards into the existing thread
- Turn the six screws down until the diaphragm rubber is slightly squeezed
Return to the Launcher User Manual
AlanB
Page was generated in 0.7944 seconds